Tengig interface not showing

[Sanjay Shaw]

Hello,

I am using a Cisco ME 3800 switch with 24 Gig and 2 Tengigabit interface. But after configuring the Tengig int with ip add and negotiation it is no know visible in the switch. Instead TenGig I am seeing two (Gi0/1 and G0/2). Not even showing the Tengig in the running config. PFA.

Hope any one in the forum has the solution to get the tengig interface in the running config visible.        

[Sanjay Shaw]

am using a Cisco ME 3800 switch with 24 Gig and 2 Tengigabit interface. But after configuring the Tengig int with ip add and negotiation it is not know visible in the switch. Instead TenGig I am seeing two (Gi0/1 and G0/2). Not even showing the Tengig in the running config.

Hope any one in the forum has the solution to get the tengig interface in the running config visible.

[Leo Laohoo]

I'm in deploying ME3800X.  My interfaces (without SFP/SFP+) are known as "TenGigabitEthernet0/1" and "TenGigabitEthernet0/2".

[Sanjay Shaw]

Hi Leo,

Thanks for ur reply.

If I am not wrong here I have to use SFP+ for Tengig interface so that the media type could be recognized.

10/100/1000BaseTX SFP will not work in Tengig port.

[Sanjay Shaw]

After inserting SFP+  modules this got detected.