cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
537
Views
0
Helpful
1
Replies

traffic-export command in cisco 880 series router

sikusikanyika
Level 1
Level 1

hi,

i am trying to enable packet capture using the instructions found at Router IP Traffic Export Packet Capture Enhancements. i have managed all the instructions except towards the end. when i type:

Router#traffic-export interface fasteth0/0 clear

              ^

% Invalid input detected at '^' marker.

The command doesn't seem to be availble in this mode.

the command: sh ver gives

Cisco IOS Software, C880 Software (C880DATA-UNIVERSALK9-M), Version 12.4(20)T5,

2)

Technical Support: http://www.cisco.com/techsupport

Copyright (c) 1986-2010 by Cisco Systems, Inc.

Compiled Mon 08-Mar-10 15:58 by prod_rel_team

ROM: System Bootstrap, Version 12.4(22r)YB5, RELEASE SOFTWARE (fc1)

any help to enable me proceed from here would be helpful.

thanks

1 Reply 1

vmiller
Level 7
Level 7

Restrictions for IP Traffic Export

Platform Restrictions

IP traffic export is intended only for software switching platforms; distributed architectures are not supported.

IP traffic capture is supported only on the Cisco 1841, Cisco 2800 series, and Cisco 3800 series integrated services routers.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: