Routing

I found that there is no force-switchover command under redundancy configuration mode. How can I do a switchover from primary RSP720 to secondary RSP720?I am using SSO and NSF.C7609-2(config)#do sh redundancyRedundant System Information :------------...

I have 877 ADSL router with two issues concerning my connection. My first is that my DSL provider does not provide me with a stable service. On a daily basis my connection will drop in the morning and usually reconnects at around 896kbps average. By ...

                   Hi ALL , i have Cisco 1941 router with following IOS image:Cisco IOS Software, C1900 Software (C1900-UNIVERSALK9-M), Version 15.0(1)M5, RELEASE SOFTWARE (fc2) below mentioned commands are not working : crypto isakmp policy 5en...

Hi AllWhile on the process of getting registration code on Cisco Licensing Portal it requires Product ID and serial numberwhich single command on the console provides the output with Product ID and serial numbershow version - provides only serial Not...

I have a need to capture traffic on an ASR 1001 subinterface, but what I have found is that the Embedded Packet Capture feature is not supported on this platform.  Are there any simple alternatives to capture egress traffic on a subinterface or am I ...

hi all, It is required to import all the mac address table entries in my branch switches to the remote FTP Server. Futher I should also mention my LAN interface as a source interface, because I dont have routes to my WAN Interface from the Head Offic...

Hello.I have a problem with ISDN BRI-1B-S/T-V3. In the documentation I read:"The ability to add BRI connectivity via a WIC lets administrators maximize valuable slot space while it provides additional connectivity options, such as Ethernet, on the sa...

Hi thereseeing very strange behaviour of router router is connected to switch to provide analog when swich configured as trunk the router crash and reboot but when change to access its stable please advice mesh flash:-#- --length-- -----date/time---...

Hello, We have here an old Cisco 878 router and want to use for ISDN remote dial-in. I was able to configure the router using the console as far as I could run the Cisco SDM. But I have problems to configure the dial. In the SDM graphic interface I c...

              Hi,                    I put a second HWIC-4ES in a 3825 router and it does not work, only work the first card that is inserted, I use the slot 0 for it, the 0/0 and 1/0 work with serial card only if I put the HWIC-4ESW in this slots th...

Hi all,We have configured Netflow on ASR 9006 router,but after applying the setting we are experincing packet drop and high cpu utilisation.Router IOS-Xr version is 4.2.0Configuration is as followsflow exporter-map netflow_map01 version v9 ! transpor...

Hello,Our network is running MPLS using BGP at several remote sites. Some of these remote sites do not have a separate internet connection so their internet traffic is backhauled to our data center on the east coast. We are opening an additional data...