419
Views
0
Helpful
1
Replies
tunnel and static NAT
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-09-2009 04:38 PM - edited 03-04-2019 03:29 AM
Hi,
I config the tunnel to route the PC-A's traffic to another site. The outbound traffic is ok, PC-A can access Internet. However, the inbound traffic does not work. what is the problem? is it the NAT mis-config? please refer attached diagram
rdgs
Labels:
- Labels:
-
Routing Protocols
1 Reply 1
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-09-2009 08:45 PM
Hi Anita,
It would be more helpful to asess the problem if you could post the running-configs of the routers on which tunnel is configured.
Lejoe
