cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1384
Views
5
Helpful
4
Replies

Unable to add ip flow monitor in management interface

djagdale97
Level 1
Level 1

Hi,

I am getting below error when tried to configure ip flow monitor in management interface.

 

Router(config-if)#ip flow monitor FLOW-MONITOR-IPV4 output
% Flow Monitor: Failed to add monitor to interface: Management Interface Unsupported

 

Please help me identify the issue.

 

Regards,

Dhiraj Jagdale

1 Accepted Solution

Accepted Solutions

pman
Spotlight
Spotlight

Thanks,

Is the interface in vrf-Mgmt?

if i'm not mistaken Netflow Export is not supported on the Gig0 interface for ASR1000,

if this is the case then you can export using standard interface.

 

View solution in original post

4 Replies 4

Hi pman,

 

Router model is cisco ASR1001-HX

 

Regards,

Dhiraj Jagdale

pman
Spotlight
Spotlight

Thanks,

Is the interface in vrf-Mgmt?

if i'm not mistaken Netflow Export is not supported on the Gig0 interface for ASR1000,

if this is the case then you can export using standard interface.

 

Hi pman,

Received same below reply from TAC. Thanks.

This is purely hardware limitation and is the architecture design of ASR1k device. Management  interface is directly connected to RP. It has no connection with FP at all so Gig 0 cannot be used for netflow or any other configuration. Its purely used for management purpose only. To provide Management access.

 

Regards,

Dhiraj Jagdale

Review Cisco Networking for a $25 gift card