09-10-2007 11:16 PM - edited 03-03-2019 06:41 PM
Hi All,
I have one Cisco 1721 which was working fine w/o any problem. But some days back due to unable to recall password being set into it, I just booted the Router with pressing Ctrl + Break key to go to rommon prompt, but it gets hanged.
Then I started the Router again, it never come up and even tried again with Ctrl + Break key, nothing comes into the console screen.
Appreciate if someone help me to make this Router bootable?
Regards,
Suresh Shrestha
09-11-2007 12:29 AM
Hi Suresh,
Whether you are not able to see anything on the console or u r getting any o/p.
What is the LED status of the ports?? Showing up or down!
Rgs
09-11-2007 09:43 PM
Hi Balaji,
I can not see anything on the console at all.
LED I can see PWR & OK (Green). No other LEDs lighted.
Regards,
Suresh
09-11-2007 01:57 AM
Hi Suresh ,
Connect console cable to router and Try out with verious baud rates starting from min.value ...
At one point u should be able to access the router.
configuration register value may not be 0x2102 when you attempted to enter into rommon mode.
Thanks,
satish
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide