09-22-2020 02:22 AM
Dear all,
I have a Site to Site VPN configured into a CISCO RV340W model. It works correctly and i am able to reach the remote network.
That remote network is 192.168.30.X.
The local network is 192.168.0.X.
Then, I have configured a PPTP VPN. The IP I get when connecting through PPTP is 192.168.222.x.
From the PPTP VPN I am able to reach the 192.168.0.X, but unable to reach the remote network: 192.168.30.X that shoud be accesible from the site to site VPN, after reaching the cisco router.
Any ideas of what i am doing wrong?
Any help would be appreciated.
09-22-2020 02:54 AM
You need to add 192.168.222.x. in Allow ACL site to site vpn. to reach remote site.
09-22-2020 07:52 AM
Dear BB,
Many thanks for your quick answer.
Just to clarify, the subnet 192.168.222.X, has been created automatically when I enabled the PPTP server.
I have disabled the firewall, so no ACL should be needed. is that right?
In case I am wrong, what is exactly what I have to do? you mean an Access Rule?
Many thanks for your help and patience
09-22-2020 10:45 PM
Hello,
I think you need to add the PPTP assigned subnet (192.168.222.x) as a Local Group on the router that serves as PPTP server, and as a remote group on the other side. Scroll down to the 'Local Group Setup' in the document attached.
09-25-2020 12:11 AM
Hello,
Many thanks Georg,
That is already done. Actually it is configured as "any", so I should be able to connect from any subnet.
Unfortunately, from the remote server I can only ping the main subnet: 192.168.0.X
It seems that It cannot stablish a VPN to both subnets at the same time.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide