1093
Views
0
Helpful
3
Replies
Unable to upload Core file WLC 5520
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-23-2020 11:58 PM
I am not sure how to upload the file if the WLC is the one that is not active but standby.
I must reboot the WLC to get it to active.
I have ben following this document.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-0/configuration-guide/
Labels:
- Labels:
-
Other Community Feedback
3 Replies 3
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-24-2020 02:59 AM
Post the complete output to the WLC command:
sh crashinfo
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-24-2020 05:12 AM
- Check if this document can help you :
M.
-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-25-2020 01:06 AM
Hello
Just to clarify what type of file are you trying to upload to the wlc?
Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.
Kind Regards
Paul
