unequal load balancing sessions for VPDN L2TP not supported on cisco prodect ?

[khder sliman ali]

hello guys

is unequal load balancing  sessions for VPDN L2TP not supported on cisco prodect ?

becouse i see only  fail-over and equal loadbalancing on cisco documentation , for example :

for loadbalancing this is the cisco radius attributes :

cisco-avpair  +="vpdn:ip-addresses=1.1.1.1,2.2.2.2", 

and for failover :

cisco-avpair  +="vpdn:ip-addresses=1.1.1.1/2.2.2.2", 

so can anybody help please , i have LAC and 2 LNSs  , and i need to configure unequal load balancing  on my lac  ,

for example 75 % of l2tp sessions on LNS1 and 25 % of sessions on LNS2,

thank you .

[Hitesh Vinzoda]

Hi there,

If you are using this scenario for end users traversing through LAC & LNS, then you can create groups in RADIUS

GROUP01 =LNS01 PRIMARY

GROUP02=LNS02 PRIMARY

Then map your 30 users to GROUP02 and 70 users to GROUP01

then tie your radius tunnel attributes to the groups.

HTH

Hitesh