01-16-2012 03:10 PM - edited 03-04-2019 02:55 PM
Hi all,
I had already posted for voice modules for cisco 2811 but not able to find it. But here are a few questions regarding i
1. I am trying to configure a cisco 2811 with FXS ports . I am using an NM-HD-2V with a VIC3-2FXS. Please let me know if I am using the right modules. Also I believe we need PVDM mosules installed in the NM-HD-2V. We have PVDM-12 modules. Will that work or is 2811 compatible only with PVDM2-xx modules.
2. We are also trying to configure a cisco 2811 with PRI port. We plan to use an NM-HD-2V and a VWIC-1MFT-T1/E1. Please let me know if they are correct and if we need only PVDM2-xx modules.
3. Also we are trying to configure a cisco 3845 with PRI and we plan to use the same as in 2811 that is NM-HD-2V, VWIC-1MFT-T1/E1. And here also we are not sure if we need only PVDM2-xx DSP modules.
01-16-2012 03:19 PM
1. ISR routers like 2811 don't need NM-HDV. Only PVDM2-xx and voice VIC.
2. as 1
3. as 1 and 2.
01-16-2012 03:32 PM
Thanks for the update Paolo
1. Where do I install the PVDM2 for the 2811 ? I was assuming it has to be installed on the NM-HDV. Also if no NM HDV is needed, do I inset the VIC in one of the HWIC slots?
01-17-2012 07:43 AM
Also, can you please let me know under what circumstances are NMHDV2 used in 2811s and 3845s?
01-17-2012 09:06 AM
You can check the hardware installation manual for reference.
Please remember to rate useful posts clicking on the stars below.
01-23-2012 06:12 AM
Thanks a lot Paulo. Iam expecting to do that this week and shall let you know the results.
Thanks
Mukundh
01-23-2012 07:48 AM
Hi Paulo,
I installed the VIC3-4FXS on one of the HWIC ports and also installed a PVDM2 on the router board. i see both of them in sh diag , but the voice FXS interfaces are not showing up in sh ver or the sh voice port. Please let me know how to proceed.
Thanks
Mukundh
01-23-2012 08:20 AM
Hello,
I tried a different IOS and it is working.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide