voice vlan configuration

[NUMAN FARUK KARAKAS]

Hello ,

I am configuring voice vlan but there is problem

here my config

test#conf t

Enter configuration commands, one per line.  End with CNTL/Z.

test(config)#interface gigabitEthernet 1/0/7    

test(config-if)#authentication host-mode single-host  (even ı did this ,it doesnt seen)

test(config-if)#end

test#show running-config interface gigabitEthernet 1/0/7

Building configuration...

Current configuration : 172 bytes

!

interface GigabitEthernet1/0/7

switchport mode access

switchport voice vlan 150

authentication port-control auto

dot1x pae authenticator

spanning-tree portfast

end

but it is still triy to authenticate with 802.1x and ı dont want it

*Mar  1 01:57:50.584: %ILPOWER-5-POWER_GRANTED: Interface Gi1/0/7: Power granted

*Mar  1 01:57:50.652: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet1/0/7, changed state to down

*Mar  1 01:57:53.751: %LINK-3-UPDOWN: Interface GigabitEthernet1/0/7, changed state to up

*Mar  1 01:57:54.752: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet1/0/7, changed state to up

*Mar  1 01:57:57.358: %AUTHMGR-5-START: Starting 'dot1x' for client (0080.9fae.13d4) on Interface Gi1/0/7 AuditSessionID AC13FEC800000040006BE843

*Mar  1 01:59:24.489: %DOT1X-5-FAIL: Authentication failed for client (0080.9fae.13d4) on Interface Gi1/0/7 AuditSessionID

what is the right config , please help me (voice vlan config with 802.1x)

[Bilal Nawaz]

Duplicate post - original in the LAN R&S section.

Please rate useful posts and remember to mark any solved questions as answered. Thank you.

[NUMAN FARUK KARAKAS]

i didnt want to mark correct answer, it was mistake

ı just worry about people pass the discussen over there