- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-16-2023 11:46 AM
Recently, when I log into my switches (SG350X-48), the webpage is super slow to load. it shows "processing data 60%". then sometimes it stops. sometimes it doesn't finish. sometimes it does load but the graphics (links to pictures) are missing.
I have a few of the SG350x-48s in 3 separate stacks. Each stack seems to do the same slow-load. I thought it was my browser (Firefox) but it happens on other browsers. Also this browser is set to delete cache and cookies at close.
What can I do to speed this up? or is this just how it is? Reboot (which takes down the network)? Any general thoughts?
Thanks.
Solved! Go to Solution.
- Labels:
-
Other Routing
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-16-2023 01:01 PM
Login SSH and check the logs, most of the suggestion reboot (in the maintenance window)
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-16-2023 01:01 PM
Login SSH and check the logs, most of the suggestion reboot (in the maintenance window)
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-16-2023 01:56 PM
Thank you for your response. (This is going to be a bad question) How do I reboot the switch? The original engineer left and i took over; I'm trying to learn how to run these switches. thanks.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-16-2023 01:58 PM
ssh to device and issue
#reload
