Re: WIC-1T

boneysia_vicki · ‎09-19-2006

HI,

I am confusing which cable i have to choose for 1 port WAN interface,is RS-232 or V.35?

Thanks

desai.jaideep · ‎09-19-2006

Hi

What is the termination of your modem?its a V.35 or an RS-232?Dpending on that,the cable will be selected.

Pls give the make and part no of your modem...it will help us.

Regards

JD

lgijssel · ‎09-19-2006

This is not related to your WIC-1T. It rather depends on the type of connection you have:

On the WIC-side, all connectors are the same but you need to order the correct cable for your modem/interface.

You should check with the provider of the leased line which interface will be used.

Regards,

Leo

boneysia_vicki · ‎09-20-2006

The router will connect to 1.5Mbps lease line.

desai.jaideep · ‎09-20-2006

Hi

Can u give the modem make and part no?

Regards

JD

lgijssel · ‎09-20-2006

That still doesn't say anything about the interface. It is likely to be either X21 or V35 but as I stated previously, you will have to ask the provider about this.

Regards,

Leo

boneysia_vicki · ‎09-20-2006

but the modem is provide by the ISP,we have to ask from them?

desai.jaideep · ‎09-20-2006

Hi

Yes you have to ask them.they will be doing their part by terminating their part...you have to do and start from there.

Regards

JD

ali.qureshi · ‎09-24-2006

That all depends which device you want to connect with. Like, if you want to connect with a Radio Modem, you probably want V.35 DTE. For a DXX connection, many vendors use RS232. Consult with your Service Provider or the Equipment manual.