08-06-2008 01:42 AM - edited 03-03-2019 11:02 PM
I am trying to configure X25 over TCP.
Serial interface conf:
interface Serial0/0
no ip address
encapsulation x25 dce
no ip mroute-cache
x25 address *******
In the routing table i have the following entry:
x25 route .* xot <IP Adress>
The remote hosts Ip address is reachable, but when I'm trying sh x25 vc nothing comes up.
I am new to x25, can anyone tell me what is wrong with my conf
Thank you in advance
08-06-2008 02:28 AM
Fuad,
Check your config against the below config example:-
http://www.cisco.com/en/US/tech/tk713/tk730/technologies_configuration_example09186a0080093c0e.shtml
HTH>
08-06-2008 02:46 AM
I checked it before. The serial interface is up, and the protocol is up, but sh x25 vc still shows me nothing. In fact, it showed me x25 details only first time I typed in the command.
08-06-2008 02:55 AM
Have you performed the trouble shooting/debugging at the bottom of the config example?
08-06-2008 03:01 AM
Yes, I have done it, debugging and sh x25 vc returns me nothing
08-06-2008 03:12 AM
No output at all?? I would proably try a re-load!
08-06-2008 05:08 AM
The issue is solved, thank you
08-06-2008 05:16 AM
np - not sure I hepled!
08-06-2008 05:33 AM
I forgot to set up clockrate on the interface ))
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide