Cisco SDWAN
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-14-2024 11:40 PM
Can we use same IP Address for Sysem IP and VPN 0 of a vBond and vSmart
- Labels:
-
SD-WAN Architecture
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-14-2024 11:43 PM
No you can not
MHM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-15-2024 12:28 AM
Dear Can you please tell me what is the reason for it?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-15-2024 12:34 AM
System IP is like router ID in ospf/eigrp/bgp
You can not have same router ID in your network' even if this system IP not need to know by underlying but it identify the device.
Use same system ID in two device make issue in edge and vmanage to connect to these device.
Avoid that
MHM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-15-2024 12:01 AM
Always suggest to look at the deployment guide and guide lines :
https://www.cisco.com/c/dam/en/us/td/docs/solutions/CVD/SDWAN/SD-WAN-End-to-End-Deployment-Guide.pdf

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-15-2024 01:20 AM
Control connections between devices with the same systemIP are not established.
Please rate and mark as an accepted solution if you have found any of the information provided useful.
