Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
675
Views
0
Helpful
1
Replies

Enable Data Stream in Vmanage

virenderboora
Level 1
Level 1

‎02-14-2023 12:35 AM

we need to enable data stream in Vmanage for Packet capture. As per recommendation we need to configure either of below one:

Management IP address and VPN 512
Transport IP address and VPN 0

can anyone please confirm whether we should configure MGMT IP Address or Transport IP address.  Also currently these IP are not pingable from CEDGE device. so would we be still able to capture traffic or we need to enable ping first to capture traffic via Vmanage.

Labels:
0 Helpful
1 Reply 1

husseino
Cisco Employee
Cisco Employee

‎02-16-2023 11:43 PM

The simplest way to configure this is to use the system option. This option is also the best option if you have a vManage cluster. With this option you don't need ping enabled, the captured traffic will be sent on the control tunnel to vManage from the edge device.

0 Helpful
Customers Also Viewed These Support Documents

Review Cisco Networking for a $25 gift card