888
Views
5
Helpful
1
Replies
use of weight command
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-14-2023 11:43 PM
when do we use weight command in Viptela SDWAN mostly
1 Reply 1
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-15-2023 01:27 AM
Weight is configured under tunnel interface. It is used for load-sharing. Default value is one. If you configure circuit T1 With Weight 10, and T2 is with default weight=1. For a specific destination, if both tunnels are used, ECMP is used by default, with weight 10 packets will got to T1 and one packet goes to T2 following the associated weight value.
