I can not see storage added

[Joel Mfunga]

Hi everyone, i have thow problemes

1. I can not see the storage added

2. Vmanage runs and after 5 sec shutdown.

Please help me or guide me.

[Torbjørn]

Can you see the file in your appliance folder if you run the following?

ls -ahl /opt/unetlab/addons/qemu/vtmgmt-20.7.1

It could be an issue with permissions. Run the following command to see if it makes a difference

/opt/unetlab/wrappers/unl_wrapper -a fixpermissions

You should also make sure to wipe the node after making changes to the appliance folder for the changes to take effect in your lab. 

[Joel Mfunga]

I have done what you asked me but Vmanage can not run

[shambhu.kumar]

Hello Joel,

Please delete it and re-create using below CLI

1-  mkdir /opt/unetlab/addons/qemu/vtmgmt-20.7.1
2-  Copy file into folder using winzip/filezila
3-  cd /opt/unetlab/addons/qemu/vtmgmt-20.7.1
     mv viptela-vmanage-20.7.1-genericx86-64.qcow2 virtioa.qcow2
4-  /opt/qemu/bin/qemu-img create -f qcow2 virtiob.qcow2 100G
5-  cd

 /opt/unetlab/wrappers/unl_wrapper -a fixpermissions

please assigned 24 GB RAM at least.

Regards

Shambhu Kumar

[Joel Mfunga]

Thank you Kumar. I will try it tomorrow I am at work at this time.

[Joel Mfunga]

Hi Sir, i have assigned 24GB of RAM to Vmanage but it is doing the same things, means boot and shutdown but when i reduce it to 4GB it boots but nothing is going on...