I facing a situation when the client navigate and all the traffic comming is forwading to the switch core and then to firewall and this is forwarding to appliance ForcePoint "WCCP" to apply a NAT and back the flow to the firewall again by other port to finally out to internet.
Now we are planning to migrate to SD-WAN the site with DIA, and reading the documents cisco about DIA Deployment, I found that DIA apply a NAT on VPN 0, so that a inconvenient because the appliance "WCCP" need to receive the traffic with the source IP of the client pc due that Forcepoint needs to apply the NAT.
Does anyone know a workaround to work with appliance WCCP?
Regards.