08-17-2023 05:41 AM
Hi ,
I have a multi HUB SD WAN network .
In GUI you can enter the monitor network and on real time test on demand remote but it has no details.
Is there a command in CLI or other GUI option which will tell me how many site are working with each HUB ?
something like "sh ip nhrp summary" we use to do in DMVPN ( of course SDWAN dosent has NHRP
08-17-2023 05:45 AM - edited 08-17-2023 05:45 AM
I will send you message.
08-19-2023 09:31 PM
HI ,
Did you send me message ?
08-17-2023 11:38 PM
Hi,
in SD-WAN tunnels use BFD. There is no exactly such command but what is normally used (both for verification and troubleshooting) is "show sdwan bfd sessions" which shows status of tunnels.
08-19-2023 09:30 PM
HI Kanan,
BFD will run for some time also in non "in use" tunnels like on demand for VOIP after a call ended and tunnel didnt "shut" yet.
so it is not an accurate result
Thanks
08-19-2023 11:01 PM
I don't remember that DMVPN shows tunnels even after spoke-to-spoke is expired (phase3) with "show dmvpn". "show ip nhrp" is protocol level command which does not exist (even similar form).
Logic is no tunnel, no output (i.e no bfd, no result).
In SD-WAN you don't have such output.
08-19-2023 11:37 PM
the tear-down time of the tunnel is meaningful since i am talking aboput the hubs and all of the Voip sessions start ( signal ) there and only then move to P2P ( RTP )
So if i test BFD on HUB it is not the true number
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide