show sdwan control connections

[RS19]

For the below commad in cEge, in normal scenario it should show only vSmart and vMange.

Plse claify if myunderstandng is correct ? Does vBond will be visible in the output ?

show sdwan control connections

[RS19]

My understanding is that only vSmart and vManage should be visible. Not sure why vBond is visible. 

This means some problem, any idea what could be the problem ?

[MHM Cisco World]

The edge connect to vbond for short time to get list of other controller

Then it connects is remove and you must see it in history only after that

MHM

[RS19]

I am facing issue similar to the below

Solved: SD-WAN 19.2.3 - vBond create unexpected connection to vEdges - Cisco Community

[Kanan Huseynli]

Hi,

I already replied in another topic. Connection to vbond from vedge point of view is temporary - transient.

WAN Edge devices onboard in a similar manner but drop the transient SD-WAN Validator connection and maintain DTLS/TLS connections with the SD-WAN Manager and Controllers.

https://www.cisco.com/c/en/us/td/docs/solutions/CVD/SDWAN/cisco-sdwan-design-guide.html#ControlConnections 

So, it is normal that you have only vsmart and vmanage in show sdwan control-connection output

[RS19]

But in my environment, I am not able to see vManage but I am able to see both the vBond. Not sure what is the cause of this ?

[balaji.bandi]

what version of code running.

Once cedge onboarded correctly yes you see only those 2. Initially you see vbond but, once all sync done, you see vManage and vsMart only.