Resolved! Hoe to get cisco ASAv demo license
Guys I am running cisco asav unlicensed but it is restricted to 100 Kbps. Please help me with the procedure to get demo license for it.
Forum Posts
Greetings all. I have this little network I am working on and I have just came across an issue. The command I am trying to implement is"event manager applet BACKUP_CONFIG" . However, my issue stems from the fact that my other switches have taken this...
Hi, We have a Cisco Firepower 1120 and want to use some of the available ethernet Ports as a "dumb switch" to literally pass traffic through. We currently have (for resilience) 2 WAN NTE's which each plug into Cisco Router which in turn then plugs in...
Hello everyone, I would like to know if it is possible to implement Remote Access VPN on Cisco Secure Firewall while running in Evaluation Mode? I have already completed all the required configuration steps and enabled IPsec/IKEv2 with the DES algori...
Can someone provide me with the SKU information of the Universe Permanent License Reservation for the ISA-3000-2C2F-FTD series for offline deployment?
Resolved! web server hosting
Dears, My company is having a domain name xyz.com.ae and we receive email on this domain name, uptill today we don't have a company webserver and my management is planning to host a company webserver to one of the hosting services company in US (becz...
Good Afternoon all , I am looking to configure my ASA in such a way that it allows some public IP ranges from the internet to access a private server residing within our internal network ( port 443 ). I would also like the the destination NAT mappi...
Hi folks,Raising within this community board because it had the most hits for SSH questions,I have a number of "%SEC_LOGIN-4-LOGIN_FAILED" failed SSH authentication attempts which I've tracked down to being a scanning-type behaviour from a customer's...
Resolved! FTD API on FMC managed device
Hi,Is the FTD API available when the device is centrally managed by FMC or in this scenario we must rely on the FMC API only?Regards.
HiQuick question, Is it possible to Configure a RB VPN on an FTD using a Loopback Interface.??I ask because I have been requested to set up one but the thing is the peer IP I have to use my side is not one of the FTD Interface IP Addresses, Also is t...
Hi allWe have a pair of ASA5516-X devices, running as an active/standby pair. Several times a day, the active device will stop forwarding traffic so all users lose connectivity to all data, applications and services. There is no error message in the ...
I have two FTD 1140ns managed by an FMCv. Both are running 7.6.2. I enabled portscannig in detection mode some time ago. I noticed quite a few of my local IP addresses scanning out to Outside (public) addresses. I know this is a nubie type of questio...
The "Securely Traversing IACS Data across the IDMZ Using Cisco Firepower Threat Defense Design and Implementation Guide" refers to the use of FMC as the management platform.Is there any reason why FDM could not be used? I am particularly concerned ab...
Hi, In FTD v7.6.2 I have and access rule to block incoming traffic with destination port ssh,rdp and telnet. but,upon checking the logs, traffics was block using this rule with destination ports for others not specified in the rule(dns, snmp,ldap etc...
Hello! We have many devices affected by the clock-signal issues. Cisco does replace the units with repaired/fixed ones. I have received some ISR4321 routers with the fix applied (pictures attached). The Cisco provided fix is of - well - mediocre qu...
