How to send from a Switch C3850 the NAS-Port-Type Ethernet

[adrdiaz]

Hello Team,

I hope you are doing great,

I have an external Radius Server (Secure W2 Radius), in which a have a Network Policy for Dot1x in which the only condition I have is NAS-Port-Type Ethernet but It seems that the Switch is not sending the Value Ethernet to my external Radius Server to match this condition. How can I set up the Catalyst 3850 to send this Attribute to the Radius Server. 

Thank you in advance for the support.

Regards,

I would like to know any example I can use for this implementation. 

[MHM Cisco World]

https://www.cisco.com/c/en/us/td/docs/ios/12_2sb/feature/guide/rd_naspt.html

Check this link

MHM

[adrdiaz]

@MHM Cisco World 

I found this doc https://www.cisco.com/c/en/us/td/docs/ios/bbdsl/configuration/guide/bba_extd_nas_port.html#wp1049275

I am still not getting which value should I use for NAS-Port-Type Ethernet to be sent from the Switch.

I found this note interesting

Note: If you enable the extended attribute 61, format e with either type 5 (Virtual) or type 15 (Ethernet) will not function, because these types require an additional value to be set (the extended attribute 61 values 30-34).