04-11-2019 03:05 AM
Dear Cisco Community,
we currently have the following problem with our C460 M4:
We are running Firmware 4.0(2c) and ESXI 6.7U1 Cisco Version. Our VICs(1225) are in Slot 4 and 5.
Although they worked before, they somehow show up as not active and are not configurable via CIMC GUI or SSH.
Example of VIC in slot 4:
PCI Slot 4: Product Name: N/A Serial Number: FCH19347QND Product ID: UCSC-PCIE-CSC-02 Adapter Hardware Revision: 6 Current FW Version: N/A VNTAG: N/A FIP: N/A LLDP: N/A PORT CHANNEL: N/A Configuration Pending: Cisco IMC Management Enabled: no VID: N/A Vendor: N/A Description: Bootloader Version: N/A FW Image 1 Version: N/A FW Image 1 State: N/A FW Image 2 Version: N/A FW Image 2 State: N/A FW Update Status: N/A FW Update Error: N/A FW Update Stage: N/A FW Update Overall Progress: N/A
Adapter List slot-number: 4 serial-number: FCH19347QND card-type: 3 asic-type: 1 product-id: UCSC-PCIE-CSC-02 asic-name: sereno hw-part-no: 73-14093-09 hw-revision: 6 i2cLogicalBus: 72 new-card: no active: no standby-power: no overtemp-condition: no fan-running: no ncsiPackageId: 1 eth-interface: eth0 bmc-mac0: e4:aa:5d:13:ef:1b bmc-mac1: e4:aa:5d:13:ef:1c sereno-mac: e4:aa:5d:13:ee:ff ipAddress: 127.16.4.1 remoteIPAddress: 127.16.4.2 virtual-eth-if: eth0_mac3.4043 actions-blocked: yes capabilities: 0x1 diagnostic-mode: no UCSM-mode: Standalone description:
We already tried going back and forth with firmware upgrades, but no success.
Does anyone know how to get these cards working again?
Thanks in advance and kind regards
04-28-2019 02:25 PM
In the CIMC, inventory, VIC adapter list, each VIC card should have the option to reset it to factory defaults.
I would try that, and then come back and see if you can configure it/them.
Kirk...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide