11-13-2022 08:14 AM
Hello friends, I am quite annoyed with my Cisco Server, I wanted the server to get started when power is back. But I am starting the server manually and in between there is a lot of time where my server is down.
I heard about Cisco Integrated Management Controller (CIMC) that I should configure policy on such thing, but CIMC is too old that it only works through adobe flash player which is discontinued.
So please, can someone please suggest me any other alternative that I could set this policy to make sure I won't manually start my server.
11-13-2022 08:28 AM
You can look below document :
get palemoon browser so you can access CIMC GUI
11-13-2022 01:48 PM
You should be able to SSH to the CIMC IP address, login and run these commands to set the power restore policy:
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: