Enable Cisco Server c220 to start when power is back online

[amanuelk]

Hello friends, I am quite annoyed with my Cisco Server, I wanted the server to get started when power is back. But I am starting the server manually and in between there is a lot of time where my server is down. 

I heard about Cisco Integrated Management Controller (CIMC) that I should configure policy on such thing, but CIMC is too old that it only works through adobe flash player which is discontinued. 

So please, can someone please suggest me any other alternative that I could set this policy to make sure I won't manually start my server. 

[balaji.bandi]

You can look below document :

https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/c/sw/gui/config/guide/3_0/b_Cisco_UCS_C-series_GUI_Configuration_Guide_301/b_Cisco_UCS_C-series_GUI_Configuration_Guide_201_chapter_011.html#concept_68CCB1BE65434C95BDFF1BF658894426

get palemoon browser so you can access CIMC GUI

[Wes Austin]

You should be able to SSH to the CIMC IP address, login and run these commands to set the power restore policy:

https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/c/sw/cli/config/guide/4_0/b_Cisco_UCS_C-Series_CLI_Configuration_Guide_40/b_Cisco_UCS_C-Series_CLI_Configuration_Guide_40_chapter_011.html?bookSearch=true