04-25-2012 08:03 PM
Hi,
I am facing problem on Cisco Nexsus 7K. Traffic not flowing on port eth 3/47. Physical link and line protocol is also up.
Then I connected to laptop by providing static IP and able to ping another end. But not working on Nexus Eth 3/47.
I also tried the same configuration on another port Eth3/2 but no luck.Then tried for Eth3/45 and started working on same configuration. At that time I found the attached error.
Regards,
Sunil
04-26-2012 05:49 AM
Hi Sunil,
Have you confiremed the speed and duplex matches on both sides?
Thanks,
Carlo
05-09-2012 09:37 PM
Sunil Patil wrote:
Hi,
I am facing problem on Cisco Nexsus 7K. Traffic not flowing on port eth 3/47. Physical link and line protocol is also up.
Then I connected to laptop by providing static IP and able to ping another end. But not working on Nexus Eth 3/47.
I also tried the same configuration on another port Eth3/2 but no luck.Then tried for Eth3/45 and started working on same configuration. At that time I found the attached error.
Regards,
Sunil
The R2D2 error is indicative that there is an issue with the 4-port ASIC which controls communciation with this port.
You've got a hardware problem. Contact the TAC and have the module RMA'd.
Cheers.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide