cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1070
Views
0
Helpful
1
Replies

EVPN Construct Mapping

visitor68
Level 5
Level 5

Folks - I am trying to understand the mapping between EVPN constructs. Can someone please validate my understanding, as described in the following bullet points?

 

  1. A tenant (Say, Tenant 1) may be assigned multiple L2VNIs (Say, VNI 10001-10005), one for each of 5 VLANs
  2. Then those L2VNIs are mapped to the same Tenant VRF (Let's call it VRF 1. Each Tenant is typically assigned one VRF. )
  3. Then VRF 1 would be mapped to a single L3VNI

This mapping implicitly resolves to the idea that multiple L2VNIs get mapped to one L3VNI. Is that correct or does each L2VNI get mapped to its own L3VNI?

1 Reply 1

Review Cisco Networking for a $25 gift card