08-02-2004 11:53 PM
hi
i have a problem
if i wnat to setup static lu point to ip address
i will need two line to define
but in my cx site have more than one thousand pc
so i need to define
client ip x.x.x.x lu 2
client printer ip x.x.x.x 3
plus 1000 pc
it will exceed two thousand command line
how many capacity does 7507 have
tks
08-03-2004 03:28 AM
can't you divide 1000 pcs into different subnets and define pools for them instead of static IP address ?
What is the motive behind static adressing ?
Serhat
08-21-2004 01:50 AM
Hi,
i found this in the CCO:
Handling Large Configurations
The largest size nonvolatile random-access memory (NVRAM) planned for the Cisco 7500 series routers is 128 KB. The maximum number of nailing commands that can be stored in a 128 KB NVRAM is approximately 4000. However, large configurations may map as many as 10,000 IP addresses to LUs.
To maintain a configuration file that exceeds 128 KB there are two alternatives. The configuration file can be stored compressed in NVRAM. Or, the configuration file can be stored in Flash memory that is either internal Flash or on a PCMCIA card.
look at this Link:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios112/bclunail.htm
cu thomas
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: