Is there a document that outlines the steps on how to setup FCoE on 5548UP. I am trying to set it up in private environment where my C260 VIC's are directly connected via FCoE cables to the 5548 and the storage Arrays attached directly to the 5548 as well via FC cables. I took a stab at this and I am afraid that I am doing something wrong, flogi shows the Arrays WWN but cannot see the hosts no matter what I do and I am kinda new to Cisco stuff so any help would be truly appreciated.
Are the local vfc interfaces up ? Can you send us the config ?
I liked this book for fcoe:
http://www.scribd.com/doc/60158853/h6290-Fibre-Channel-Over-Ethernet-Techbook
even though it has brocade configs, it clearly outlines fcoe configs of nexus 5000.
Hope this helps
Raj
You may referecne below guide:
Managing vHBA in C260 CIMC
Configure FCoE on Nexus5000
The version may not match your environment. FYI
My issue is fixed, in CIM I needed to specify the VLAN on the vHBA.