03-13-2019 04:15 PM
I have my HyperFlex installer stood up and configured, but now I need to change it's IP address.
Is there a method for doing this?
Any caveats to doing this?
Thanks
03-19-2019 01:30 AM
You can modify it a few different ways.
1. Re-deploy the Installer VM with the correct IP configuration
2. Edit /etc/network/eth0.interface with the correct configuration and reboot to take effect
3. You can use `ip addr set` command
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Log in to Community