cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
809
Views
1
Helpful
2
Replies

N7K queries

mayank.parekh
Level 1
Level 1

Dear Team,

we have following queries regarding N7K .

1) How Can we access N7K via GUI .

2) Can we remove switch Slot without shutdown (it is hotswape ? )

3) Shutdown Command to power off Complete N7K ?

4) Access list for permit sepcifc user to use SSH access of N7K remaning deny all .

5)Can we configure Dual DHCP server relay agent on interface ? and how its works ?

Please Suggest & Support for same

Regards

MAK

2 Replies 2

Chad Peterson
Cisco Employee
Cisco Employee

Hi MAK,

My answers are inline

1) How Can we access N7K via GUI .

-There is no direct GUI on the N7K, however it can be managed via DCNM (Data Center Network Manager).  You can find more about it here:

http://www.cisco.com/en/US/products/ps9369/index.html

2) Can we remove switch Slot without shutdown (it is hotswape ? )

-Yes, all modules are hotswapable.  Once you press the each ejector lever, the module is disconnected from the backplane.

3) Shutdown Command to power off Complete N7K ?

-There is not a shutdown command to shut down the switch

4) Access list for permit sepcifc user to use SSH access of N7K remaning deny all .

-I don't believe there is a way to do this.  The only way to limit SSH access is to apply new policies to CoPP to allow some IPs vs other

5)Can we configure Dual DHCP server relay agent on interface ? and how its works ?

-When you have multiple DHCP relays defined on an interface the DHCP discover and request will be sent to each defined server.

Hope that helps

Chad

Hi Chad,

Thanks For your valuable support , Its Realy help me to clear basic points.

Thanks

Mak

Review Cisco Networking for a $25 gift card