Hello Didi Hermawan,
I would configure the sdlc port as given below; instead of configuring "sdlc address 01 vmac 4000.1012.0043"
Here is your current configuration:
sdlc address 01 vmac 4000.1012.0043
sdlc partner 4000.0600.1ce2 01
Just configure like the following :
sdlc address 01
sdlc partner 4000.0600.1ce2 01
So, your configuration will be like following :
interface Serial1/1
description connect TO HI-0011 NPA 21#1
no ip address
encapsulation sdlc
half-duplex
no keepalive
nrzi-encoding
clockrate 9600
sdlc role primary
sdlc vmac 4000.0600.0000
sdlc poll-pause-timer 200
sdlc K 1
sdlc address 01
sdlc xid 01 /* this is also missing in the current config
sdlc partner 4000.0600.1ce2 01
sdlc address 02
sdlc xid 02
sdlc partner 4000.0600.1ce2 02
configure the rest in the same way.
Do not configure
sdlc dlsw partner 4000.0600.1ce0
sdlc dlsw default
Instead configure the following :
sdlc dlsw 01 02 03 04 06 09 12 /* this will bind the PUs to the dlsw
This is if the PUs are PU 2.0, if your PUs are PU2.1, you need to configure
sdlc address C2 xid-poll command,
instead of "sdlc xid 01 "
xid-poll indicates that this PU is a 2.1 device.
You may check out the following URL, there is a good example.
http://www.cisco.com/en/US/partner/tech/tk331/tk336/technologies_configuration_example09186a0080094730.shtml
If it does not work, I would suggest you to open a Service Request with the TAC and provide the following information;
From both dlsw peer routers:
sh dlsw peer
sh dlsw cir det
sh dlsw reach
sh tech
sh log
I hope this helps.
Have a nice day and kind regards,
Hakan.
