Hi ,
I was trying to enable sflow on my Nexus9000 C9372TX and C9396PX Chassis switch .
first i cant see the feature sflow ( output attached)
Prerequisites for sFlow
sFlow has the following prerequisites:
For Cisco Nexus 9332PQ, 9372PX, 9372TX, and 93120TX switches and for Cisco Nexus 9396PX, 9396TX, and 93128TX switches with the N9K-M6PQ or N9K-M12PQ generic expansion module (GEM), you must configure the sFlow and SPAN ACL TCAM region sizes for any uplink ports that are to be configured as an sFlow data source. To do so, use the hardware access-list tcam region sflow and hardware access-list tcam region span commands. See Configuring ACL TCAM Region Sizes for more information.
Note
By default, the sflow region size is zero, and the span region size is non-zero. You need to configure the sflow region to 256 and allocate enough entries to the span region in order to configure the port as an sFlow data source.
second thing i cannot find the region sflow
SW01# show hardware access-list tcam region sflow
^
% Invalid command at '^' marker.
Please help
Thanks
