ucs c220-m3 cant boot after install esx 5.5

[silvesterluhur]

hi i have question,

i have already install esx 5.5 but, still stuck in this caption

media test failure, check cable

exiting intel boot agent

Reboot and select prooper boot device

"this is a pict"

please give me a clue about boot order,

Regards,

Silverster

[Kirk J]

Greetings.

What previous device did you install to?

The picture 1 shows esxi installer not detecting any valid storage destinations.

If you were using the onboard/embedded sata controller that is connected to the hotplug drive bays, then this is not supported by ESXi.  I have seen instances of customers creating a virtual drive via the MegaRaidSR optionROM setup config, installing ESXi, and the virtual drive disappearing on next reboot.

The error messages on the screen are just PXE boot messages, as the boot/post process did not find a valid boot device.

Please confirm what Storage controller/device you were previously attempting to install ESXi to.

Thanks,

Kirk...

[silvesterluhur]

thanks :)