Cisco RV325 CLI Commands not available "COMMAND OR FILENAME NOT FOUND"

[ErrantOsi]

Hello all,

I'm pretty new to the Cisco world so please apologizes if this is a beginner question...

I want to build a little homelab and create different subnets etc. For this I bought the Cisco RV325 VPN Router (found it pretty cheap in an second hand online shop). Now I connected myself via SSH the router and when I try to write a command I always get an error message "COMMAND OR FILENAME NOT FOUND". Also, when I just type "?" I don't get an output with the available commands.

Is the CLI not supported by this router?

Thanks in advance and regards,

ErrantOsi

[viningele]

I did find this on the Cisco site:

Cisco RV320/RV325 Command Line Interface Reference Guide Release 1.2.1.x

I've never bothered with trying CLI on any installed RV series router but I have on the SG series switches.  I decided to try on my office RV320 and I can't even log in, keep getting access denied and SSH is enabled in the Firewall section.  I I tried using PuTty, I would try using my Indigo terminal emulator but I'm already getting side tracked.