SG200-08 won't boot anymore

[guillaumemazoyer]

Hi,

When I came back home today I saw that my SG200-08 switch did not look fine.

Basically, the system LED of the switch keeps blinking and end devices connected just don't have any network.

I tried to reset the switch with the "reset" button (with a paper clip) the system LED was orange during just a second and then continue to blink.

What is wrong with the switch?

Is there a way to flash a new firmware and/or to delete the configuration file?

Thank you for your help.

[jasbryan]

Guillaume Mazoyer,

If the system light is blinking green means it didn't pull a DHCP address from DHCP server.static assign your pc ip address to 192.168.1.20 255.255.255.0 and try and get into web gui @ 192.168.1.254. If this fails try hold the reset button again for about 30-45 seconds. If you still can't access the switch then call SBSC @ 1-866-606-1866 to open a support case.

Jasbryan

[guillaumemazoyer]

Holding the reset button a little more did the trick.

Thank you for quick answer.