ASA5505 And Cisco WAP4410N

[DrSw1mmer]

Hello,

A couple of days ago, my old access point burned out. It was a proxim ap-700. Anyway, I bought a new ap and recieve it today. I have been having trouble getting it up and going. I was wondering if anybody might have any idea what I'm messing up on.

Now the 5505 has already been configured for dmz, ip 10.10.10.1/24, vlan id 13--- But when I try to input information into the ap and save it from it being connected to my laptop.. Then after that I unplug it and plug it into my 5505 in the same port as the other dead ap was in... It takes a long time to connect to it, then when I do.... I can't connect to the Internet or anything.

ip: 10.10.10.245

sub: 255.255.255.0

gate: 10.10.10.1

dns1: 8.8.8.8

dns2 8.8.4.4

[Tom Watts]

Hi Dr, can you verify the port of the ASA is working correctly?

-Tom
Please rate helpful posts

[DrSw1mmer]

Yes, I'm sure.

I followed these steps to get it going. But I'm faced with something stupid... I can connect to the ap and it says I have Internet, but when I try to go to google or anything, my browser tells me it can't connect.

I'm trying to figure out what happened.

http://www.mailbeyond.com/adding-dmz-to-cisco-asa5505

Link I used to figure most of it out..