10-24-2017 02:30 PM - edited 03-12-2019 07:32 AM
Team -- Is there a workaround for this issue?
10-24-2017 08:53 PM
I had this issue as well and had to configure the appliance using the CLI. See this article.
Good luck!
08-19-2019 06:51 AM
Realize that this is an old post, however we faced the same issue when attempting to deploy 2.8.1.4 Build 4. The appliance was being deployed in a vendor DMZ where the firewall was configured to not allow ICMP/ping to the gateway IP address. Once we enabled ICMP/ping on the firewall the IPv4 configuration script was successful. Hope this might be helpful to someone else as it looks like community support is the only option available for the Cisco CSPC appliance (tried to open a case with TAC, but it didn't go anywhere).
Chris
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide