gary_the_network_guy

I looked at the problem today again, I realized that the first switch in the switch-stack is blinkin...

it is an class 2 phone I think it requires 7W and yes LLDP and CDP are enabled.

I did not test that but that phone worked fine on a 2960-Switch.

Yes I already did, I checked out this section.Non-Cisco powered device does not work on Cisco PoE sw...

C9200-48Pshow versionCisco IOS XE Software, Version 16.12.02Cisco IOS Software [Gibraltar], Catalyst...

So I wanted to connect an IP Phone to my C9200, it is an Alcatel 8028 Deskphone by the way, The impo...

Thanks for the help so far. The output for wget https://[myipadress]/webacs --no-check-certificate o...

The output from the logging is not really helpfull either, I tried this command."show logging | incl...

No, there are no proxies or firewalls between the server and my client. I tried to ping from the pri...

The NCS status command looks good, everything is running, but it still runs into timeout.

I will, also I created a new instance from an application backup sadly It just does not work.It resp...

So just a few weeks after an Update from 3.7 to 3.9 the Cisco Prime Web App just stopped working.It ...

It was an application update, so it runs just fine, I am experiencing no issues with the actual appl...

So I updated my Prime from 3.7 to 3.9, It was not an inline Upgrade. It was necessary to create a ne...

It is a real problem, collegues are having problem regarding ESXI hosts. So I first need to look int...