Storage Networking

Hi everyone,What is Cisco Psuedo SCSI Disk Device?This Device got an error even I can see the disk array by "sh device" commande in the SN5428?

Hello,I have a SN5428 running 2.5.1-k9 version.I have a NT server with service pak 6a and i-scsi driver 2-1.2whnw I start disk admin, I see the I-Scsi disk and I assign a letter. Then I start the i-scsi manager and save the boot information.when I re...

I am a Network Administrator in the military, so I am not really certified, just military trained. Now when I get out of the military I want to pursue this career and I need to be certified so please give me a list of good certifications that will g...

Hello,I test the storage solution with a SN5438 switch. The switch is running last version 2.5.1-K9 The SN5428 is directly connected to an HitachiI have an NT server with service pack6a and driver 2.1.2Actually the SN5438 could find the disk :[SN5428...

Hiwhere can i get documentations for MDS9000 series ?i find only datas sheets on CCO web ?thanks in advanceJYP

I have tested the 5420 in iSCSI routing and iSCSI transparent routing mode and I have some question regarding security:a) about WWPns.Is it possible to determine what WWPN will be assigned to a given IP host when it connects to the AS6420?, it seem...

This is a rather general question but can someone tell me where and how is Fibre Channel best used?

Currently, is there any books or training classes available for SAN or NAS? If not, how far into the future can we plan on seeing them available?

My Switchis in [VxWorks Boot]: and I could not reach it.How could i configure and activate the ethernet interface (i think it should be the management interface) to reach it again ?I could not find any information on the [VxWorks Boot]: mode.regards

Hopefully ,ne one can dumps their tips and suggestions to me

A or B on the connector is the Tx?

Working on a project for storing data across geographically dispersed locations, I need to be able to estimate how much bandwidth that will be required to do remote mirroring. I assume the initial data has been loaded on my backup servers at the 2 lo...

Cisco SN 5428 v.2.3.1-K9 (fc8 gl-port, blinks green light)Brocade Silkworm 2800 v.2.4.1c (port 15, E-port, blinks green light) Source: "SN5428 Interoperability Whitepaper, for internal use only...)I have done as Cisco white paper says but still Silk...

I had an earlier version of Cisco iSCSI driver, 2.1.1, installed, and I thought I had removed it. However, the iscsicfg.cpl file remained in the system32 directory and I couldn't delete it.Cisco doc mentioned to run the setup program to de-install t...