Callhome
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-21-2009 09:24 AM
Running a m9134 with 3.2. Trying to configure callhome to send a user defined command when a port is disconnected.
Callhome works fine.
This also works fine when I run "callhome test".
but I can't get it to work when a interface changes status I.E up or down
I added the following
alert-group supervisor-hardware user-def-cmd "show interface description"
alert-group system user-def-cmd "show interface description"
alert-group test user-def-cmd "show interface description"
Any help would be appreciated
- Labels:
-
Storage Networking
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-27-2009 11:57 AM
I think this issue is related with the bug CSCej00680 - Interface can not be reached ping does not work.
