It is necessary to check whether axios is used in the security investigation, and it will be a situation that checks whether axios is not used in the NX-OS of Cisco MDS. Since OSS components are not released, it is difficult to investigate, so please...
Forum Posts
I have a Cisco MDS 9124 switch that currently has no OS. It looks like the latest version that is available to download is version 9 and above. However, I need version 5 to start and then I would have to upgrade in steps. Where can I get an instal fi...
Hello,I have a Cisco MDS 9148T currently running NX-OS 9.4(2a).We have received a port activation license in legacy (.lic) format, which cannot be installed on this version due to Smart Licensing Using Policy (SLP).I would like to ask:Is it supported...
Hi AllI am in the process of logging a TAC via our Partner but just wanted to see if anyone has encountered these messages before.I have a Cisco MDS 9396S running NX-OS 9.4.2a and see the below error popping up when running show flogi internal event-...
Configuration: FCIP tunnel is using a single dedicated 10G IPS port, configured for a maximum bandwidth of 3Gbps, with an RTT of approximately 20ms.When the end‑to‑end network supports jumbo frames, what MTU value is recommended? I recall seeing a Ci...
How many TCP connections (2 or 5) should be set on MDS 9220i with min=1100 and max=1250 Mbps? I'm thinking 2, but I want to be sure. Thank you
I have a Cisco Nexus 5672UP switch running NX‑OS 7.3(6)N1(1). The switch was functioning normally, but after performing a reset, the Ethernet ports on Slot 1 (ports 1‑48) are no longer visible in show interface status or show interface brief.
Resolved! DS-C9132T-MEK9 - connect datacenters
Hello , can you please tel me if i need additional licenses something like Brocade Extended Fabrics for DS-C9132T-MEK9 switch? we have to connect two datacanters about 5 km far away from each other
I'd like to check if the MDS9000 series is affected by the following article (Microsoft KB ID: 5062710).https://support.microsoft.com/ja-jp/topic/windows-%E3%82%BB%E3%82%AD%E3%83%A5%E3%82%A2-%E3%83%96%E3%83%BC%E3%83%88%E8%A8%BC%E6%98%8E%E6%9B%B8%E3%8...
hello, I would like to confirm whether the Cisco MDS 9000 series is affected by the following article:https://support.microsoft.com/en-us/topic/windows-secure-boot-certificate-expiration-and-ca-updates-7ff40d33-95dc-4c3c-8725-a9b95457578e But I can't...
I got a X c210 M7 blade running ESXi 7.0u3 but its unable to see scsi evices above 255. Any idea? I noticed the fnic driver no longer exists and only use the new NFNIC. anyone have any info on this or if the NFnix is configurable?
Hi could you please help me to provide EMC test report for Cisco MDS 9132T or CB TEST CERTIFICATE thk you for your support
We plan to replace our current MDS switches with new ones (FC SAN).I hear that this may also be possible with Nexus 9000 series but in FC mode.Is this true? Can a Nexus, such as the 93360YC-FX2, replace an MDS, such as the 9396T, in its full function...
