10-23-2019 10:40 PM - edited 10-24-2019 08:32 PM
Hi All,
Can anyone help me how to allow outside network to access one specific computer inside the office thru NAT.
Cisco Device: ISR4331
PC IP: 10.1.40.36
Please see sample config below:
!
interface GigabitEthernet0/0/0
description ***TO INTERNET***
ip address 192.168.1.74 255.255.255.248
ip nat outside
duplex auto
speed auto
!
interface GigabitEthernet0/0/1
***TO CORESW***
ip address 172.254.6.1 255.255.255.0
ip nat inside
duplex auto
speed auto
interface Vlan1
no ip address
!
ip classless
ip route 10.254.0.0 255.255.0.0 172.254.6.2
ip route 0.0.0.0 0.0.0.0 192.168.1.73
ip access-list extended NATING
permit ip 10.1.40.0 0.0.0.255 any
!
Solved! Go to Solution.
10-24-2019 12:39 AM
here is the example for bidirectional NAT ( if you have all the routing and other setup done)
ip nat inside source static 10.1.40.36 x.x.x.x
ip nat outside source static x.x.x.x 10.1.40.36
10-24-2019 12:39 AM
here is the example for bidirectional NAT ( if you have all the routing and other setup done)
ip nat inside source static 10.1.40.36 x.x.x.x
ip nat outside source static x.x.x.x 10.1.40.36
10-24-2019 07:47 PM
Hi Sir Balaji.bandim
So I have to NAT outside and also inside?
10-24-2019 10:16 PM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide