Nexus 5548UP information

[xayavongp]

Hi,

Is there a way to show from the CLI whether the switch is a 5548P or 5548UP ?

I have seen the physical labeling but wanted to a way to verify via the CLI.

[Rick1776 · Accepted solution]

You can run the "show inventory" command and it should show you what you need. You can also try "show version" but I don't think it shows up in that output.

https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus5000/sw/command/reference/fund/n5k-fund-cr/n5k-fund_cmds_show.html

[xayavongp]

Okay I see it now under PID...that was easy.

Thanks!

[Rick1776 · Accepted solution]

You can also do the command "show module" that will give you almost the same output but easier to read.