Hello
I need help with configuration of me new cisco switch SG500-28, i want to split me switch on 2 VLANS. Default vlan and second for managament of ups,serwers. SG500-28 is conected to me network by one of ours old switch SG200-26.Then i switched mode to LAYER 3.On SG500-28 i created second vlan, and now i have VLAN1 (default) and VLAN2 (MANAGAMENT), i splited ports in half 1-11 for VLAN1 and VLAN2 ports 12-24. I configured VLAN1 to get a static adress 192.168.0.224,all ports are trunk default, and they get ip adress from our server and they see our network.VLAN2 i configured to have static ip adress 192.168.10.254 , i enabled dhcp and configured, it works. BUT how i configure vlans to see each other or how to configure VLAN2 to see our network??Vlan 2 is using ports from 12-24, i tryed using port 12 with trunk mode for connection with me SG200-26 but ofcours taht didn't work.
This is me 1 cisco switch which i try to configure, i found some guides but they are for conection switch - router and i need switch - switch. Sry for me english.
