Switches - Small Business

Can I use the SG300-10MPP on a lager layer 2 network ( lager than class C).  I have layer 2 switch with vlan1 ip is 141.225.215.224/22 and default-gateway is 141.225.212.1 and with this config I am unable communicate with switch or switch can't commu...

Hello I need help with configuration of me new cisco switch SG500-28, i want to split me switch on 2 VLANS. Default vlan and second for managament of ups,serwers. SG500-28 is conected to me network by one of ours old switch SG200-26.Then i switched m...

We have DHCP setup on Windows Server 2012r2 and the range given to us by the main HQ is 10.65.112.1-10.65.112.254 (there are several exclusions under this range)Now since the range gets exhausted quickly, they provided another one 10.65.122.1-10.65.1...

I received a config from my vendor that they usualy put on a SF300 for their managed voice.  Looks like you configure general ports and PVID's to allow two vlans on one port. Is this the same as switchport voice vlan <vlanid> ? Also in the configurat...

Hi all,As far as I can tell, there's no way to do VLAN mapping/translation in the 300 or 500 series switches like you can do in some Catalyst platforms. Considering that you can set a VLAN based on EtherType, MAC address/OUI is it feasible that setti...

Hi, I have a SG200-18 switch that's been in production for about 6 months. About a month ago we had a severe ice storm and everything lost power including the switch. Afterwards I started to see very high "Packets With Errors" in the interface statis...

Hi,I have two questions about the DHCP server on the SG300:On the Address Binding page, what does the "Declined" state mean? I have a NAS device that won't pull an address, and I think that the entry with a state of "Declined" corresponds to this dev...

Hello,I have 3 SG switches that are chained using fibre. I have them configured for L3 switching. What I am trying to accomplish it that I have a live network with my clients and servers. One of the servers is going to be replaced with a server of th...

Ringraziandovi anticipatamente per l'attenzione vorrei chiedere un consiglio su come testare il throughput di alcuni switc Linksys by Cisco System, che abbiamo in azienda.In particolar modo abbiamo dei SRW2048, SRW2024p, SG200 50. Dopo aver dato dei ...

Hi,I need to buy an entry level switch with the following features:qos configurationsecurity features like port security, ACLs, NAC, IBNSlayer 3 featuresetmay or may not be modularat least 24 portsat least 6 POE portsPlease suggest the low cost model...

Is it possible to configure QinQ tunnels in switches at small business  line? What is the procedure to configure to SF300? The switches will be connected at the network edge of  the customers.

Can anyone give me step by step instructions on how to set up a port on a Cisco SF 302-08P Managed Poe Switch ..Many Thanks Rob

Hi,I have WS-C2950-24 switch... Last night i have noticed an issue in it.. Switch is reachble but unable to telnet to the switch.While i login through console... i was getting LOW ON MEMORY TRY AGAIN LATER...After i have harf rebooted the switch (Pow...