booting with mode CLI and not with the console.

[pascal.linglin]

hi,

On a SF300-08, is anybody knows how to work with CLI and not with the Console Menu Interface ?

Thank you for your help.

Pascal Linglin

[David Hornstein]

Hi Pascal.

Firstly make sure your switch is using the most recent firmware, which is now as of yesterday  1.1.2.0 .

When that firmware is running on the switch,  a textview CLI option should be seen on the main menu as per the following screen capture;

to get back to the menu, just type menu from the cli interface.

Hope i answered your question?

regards Dave

[pascal.linglin]

Hi David,

Thank you for your answer,

is it possible to change value of register to boot in mode CLI and not with that main menu ?

I don't know where to find documentation about that.

kind regards.

Pascal.

[David Hornstein]

Hi Pascal,

When I used telnet to get to the switch, it dropped me in a command line and NOT a menu.

I had to type "menu" from the command line to get to the menu  that you can see in my previous posting.

So it's there now. :-)

regards Dave

[pascal.linglin]

Thank you very much for your help.

Pascal.

dhornste a écrit :

David Hornstein

created the discussion

"Re: booting with mode CLI and not with the console."

To view the discussion, visit:

https://supportforums.cisco.com/message/3503182#3503182