Can I easily move the configuration from a SF300-24P to CBS250-48P?

[jonh001]

I have an old Cisco SF300-24P switch which is end of life (and out of ports).

I purchased a new CBS250-48P and I'm wondering if I can just load the configuration over?

[balaji.bandi]

not sure the config can be ported from that model to a new model

instead, you can configure the same offline and replace and test it.

[Flavio Miranda]

I would give it a try.

Take a look:

https://www.cisco.com/c/en/us/support/docs/smb/switches/cisco-small-business-200-series-smart-switches/smb2909-configuration-of-download-and-backup-configuration-settings.html 

[jonh001]

I looked at the configurations of both and not sure why but the config on the SF300 looked different.  It did not start with "config-file-header" - it started with some interfaces.  So I decided to just configure the new switch from scratch.

Thanks for the replies.

[balaji.bandi]

yes that is what i have suggested, they are not same, it easy to copy config and paste / test also.

[Martin Aleksandrov]

@jonh001 

You can't move the config from the SF300 switch to a CBS250 switch. Those are different hardware and software platforms. The only configuration migration tool available so far is from the legacy 200/300 series to the 250/350 series. Have a look at https://www.cisco.com/c/en/us/support/docs/smb/switches/cisco-small-business-200-series-smart-switches/smb5735-convert-configuration-files-using-the-configuration-migratio.html 

Thanks