Cisco CBS250 freezing when adding VLAN interface IP

[Dobri K]

Hello,

I'm new here. So I got the sw today, brand new - Cisco CBS250-24T-4G. I started to configure it from the GUI, adding VLANs and stuff, but when I wanted to set an IP address to a VLAN interface, it just froze. Tried to ping the sw - timed out. When I did a power reset (unplug/plug the power) it booted again from my last saved config, tried again from SSH - same thing, it froze. After many attempts I was not able to get it to work and found out that only if I choose DHCP instead of static IP, it takes the command from either GUI or SSH and doesn't freeze. 

Can someone please help me resolve this issue?

Regards,

Dobri

[balaji.bandi]

Are you trying this on VLAN 1 ? or new VLAN ID ?

[Dobri K]

I'm trying on a new VLAN ID.

[Dobri K]

I figured it out. The solution can be found here:

https://www.cisco.com/c/en/us/support/docs/smb/switches/cisco-250-series-smart-switches/KMGMT-1525_Workaround_Switch_loses_connection-PUBLISHED.html

Thanks

[Jitendra Kumar]

good to know your issue resolve...

Thanks,

Jitendra